YSS-338sJP
PRODUCT OVERVIEW
Product Overview
The YSS-338sJP is an uncompromising, reference-grade power amplifier built on an artisanal discrete circuit topology. Handcrafted to the highest technical standards, it incorporates globally scarce electronic components—over 90% of which are completely discontinued and exclusively curated by YS Sound. Every single component undergoes rigorous iterative sorting and burn-in procedures to achieve absolute symmetrical channel matching. Following assembly, each finished amplifier is subjected to three successive state-of-the-art diagnostic evaluations and must clear 200 hours of continuous full-load testing before leaving the workshop.
Specifications
| Output: | Over 800 W (Zero Distortion) |
| Output impedance: | 1–16 Ω |
| Input voltage: | 1.5 V (input sensitivity) |
| Input impedance: | Over 45 kΩ |
| Frequency response: | 1 Hz~50,000 Hz |
| Sound field width: | Over 260° |
Operating Guidelines & Precautions
Power Requirements: Connect the YSS-338sJP using a dedicated, high-quality 20A power cable equipped with an IEC C19 plug (cable sold separately).
Startup & Diagnostics: Upon powering on, the indicator light flashes for approximately 3 seconds as the unit runs an automated self-diagnostic check scanning for static electricity, short circuits, open circuits, and DC voltage. Once verified, an audible relay "pop" will sound, the indicator light will remain steadily lit, and the amplifier reaches its fully balanced operational state within one minute—requiring no warm-up period.
Handling & Placement: Houses intricate, highly sensitive discrete circuitry; handle with extreme care and place on a solid, stable surface.
Power Conservation Protocol: Power capacitors begin their operational lifespan from the moment current flows; always switch off the unit promptly after listening sessions.
Signal Purity Warning: Built with an ultra-low reactance architecture; the use of "filtered" power supplies or "filtered" signal cables is strictly prohibited.
Diagnostic Indicators & Protection: At power-on, the three indicator lights (or any individual indicator) will illuminate and flash for 1 to 3 seconds during self-inspection. If the indicators fail to extinguish after 6 seconds, power down the amplifier immediately. If the light turns off approximately 1 minute after powering down, the protection circuit is functioning correctly. If the indicator remains continuously illuminated, immediately shut off the power and contact your authorized dealer.
Previous:
Next
CONTACT US
Discover the Art of Sound Reproduction
Sorry, there is currently no content in the current column
You can check other sections
Business License